Mercury 200 Optimax Instrukcja Instalacji Pobierz pdf (Strona 23)

200/225/250 OPTIMAX

Page 23 of 38

Wiring for SmartCraft Gauges

Paddle Wheel Speed Sensor Installation (If Equipped)

PARTS PROVIDED

a-Paddle Wheel

b-Bracket

c-Flat Washer (2)

d-#10 - 3/4 in. (19 mm) Screw (2)

e-Cable Cap

f-# 6 - 1/2 in. (12 mm) Screw (4)

g-Clamp (2)

h-Connector

i-Wire Retainer

j-Spare Pin Yoke

SELECTING LOCATION

Single engine installation – Mount on paddle wheel on the transom where the propeller

blade is rotating upward. [usually the right (starboard) side] to minimize cavitation. If feasi-

ble, mount at least 2 in. (50mm) beyond the swing radius of the propeller.

Dual engine installation – Mount the paddle wheel between the engines as close to the

center line (keel) of the boat as possible. On slower, heavier displacement boats, however,

positioning it farther from the keel is acceptable.

NOTE: Do not mount the paddle wheel directly behind any strakes, ribs, intakes or outlets

for live wells or any protrusion that may cause turbulence or cavitation.

2 in.

(50mm)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Brak uwag

Mercury 200 Optimax Instrukcja Instalacji Strona 23